Master the main points and use diamond cutting wheel reasonably

Proficiency in the operation of the diamond cut wheel machine can better serve the daily production needs. The hardware is mainly focusing. When focusing, all parts of the body can not block the laser light path, be careful of burns. The software has special laser cutting machine software, which can be used with mainstream design software, such as cad, photoshop, etc.
The operation process steps of the diamond cut wheel machine are as follows:
1. Comply with the general safety operation regulations for turbine cutting machines. Start the laser strictly in accordance with the laser start procedure.
2. The operator must be trained, familiar with the structure and performance of the equipment, and master the knowledge of the operating system.
3. Wear labor protection equipment in accordance with the regulations, and must wear protective glasses that meet the regulations near the laser beam.
4. Do not process a material before it is clear whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and steam.
5. When the equipment is started, the operator is not allowed to leave the post or be entrusted without authorization. If it is necessary to leave, the operator should shut down or cut off the power switch.
6. ​​Keep the fire extinguisher within easy reach; turn off the laser or shutter when not processing; do not place paper, cloth or other flammable materials near the unprotected laser beam.
7. When an abnormality is found during the processing, the machine should be shut down immediately, and the fault should be eliminated or reported to the supervisor in time.
8. Keep the laser, the bed and the surrounding area clean, orderly, and free of oil pollution. Workpieces, plates, and waste materials are stacked as required.
9. When using gas cylinders, avoid crushing the welding wires to avoid leakage accidents. The use and transportation of gas cylinders should comply with gas cylinder supervision regulations. It is forbidden to explode gas cylinders in the sun or close to heat sources. When opening the bottle valve, the operator must stand on the side of the bottle mouth.
10. Observe the high-voltage safety regulations during maintenance. Every 40 hours of operation or weekly maintenance, every 1,000 hours of operation or every six months of maintenance shall be carried out in accordance with regulations and procedures.
11. After starting the machine, the machine tool should be manually started in the X and Y directions at low speed, and check to confirm whether there is any abnormality.
12. After inputting the new part program, test run it first and check its operation.
13. When working, pay attention to observe the operation of the machine tool to avoid accidents caused by the cutting turbine going out of the effective stroke range or two collisions.
14. Typesetting programming, this is the step of putting the workpiece to be cut into the plate through virtual, ensuring that it will not cut outside.
15. Lift the sheet metal. At this step, pay attention to placing the materials as straight as possible, otherwise it will be a little harder to face the side.
16. Replace the laser head and other accessories according to the board thickness. Different plate thicknesses correspond to different laser heads.
17. Seek edge adjustment parameter cutting.